Cheer on our compatriots in the AT-AT corp as they take on the rebellion scum!
This design is an AT_AT Imperial Walker. It was printed at a total length of 2ft long and 2ft tall. It took about 160 hrs to print. The original model was taken from the internet. I optimized it to be 3d printed. I also, redesigned the neck and made the legs, feet and neck articulated.
Investigating how to get my OctoPi on to the corporate WiFi so I can remotely control the TAZ 6.
wlan0 unassociated Nickname:” ” Mode:Managed Frequency=2.412 GHz Access Point: Not-Associated Sensitivity:0/0 Retry:off RTS thr:off Fragment thr:off Power Management:off Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 lo no wireless extensions. eth0 no wireless extensions.
I’ve done this before with my previous printers. Seems to work well with the TAZ 6 as well. Will always get some extraneous extrusion, no matter what you do. Minimizing it is worthwhile.
Not sure if anyone else runs into this but when I print skirts there is a decent chance they get pulled into the print. After I saw how the Prusa i3 Mk2 primed its nozzle by printing a line at the front of the bed where the printer never usually prints I got jealous.
One of my friends turned me on to this site. LOTS of information on Linux distributions, applications, etc. and how to install, configure, and troubleshoot. Nice, easy-to-use interface.
The site for people who want to establish the Network Server with CentOS, Ubuntu, Fedora, Debian